Innovative Ideas Limited LCD Monitor Arm 9103 User Manual download pdf

LCD Monitor Arm

Model No. 9103

INSTRUCTIONS

The IOP Monitor Arm Model 9103 comes in three parts.

Each component is sold separately.

1. Mount assembly (instructions enclosed separately)

2. Monitor Arm assembly

3. Adapter Bracket

The Monitor Arm is easily assembled following these simple

steps.

Be sure the mount is securely fastened to the surface

before beginning.

tep 1 Attaching the Arm to the Mount

Once the mount is secure, insert the shaft of the LCD Arm into the

mount as shown below in Illustration 1 (Mounts will vary).

Illustration 1

Step 2 Attaching the Tilter to the Adapter Bracket

Carefully remove the base from the flat panel monitor. For removal

instructions, see your Flat Panel User’s Guide.

If the adapter bracket is already attached to the tilt mechanism,

skip this step and continue with step 3.

If the adapter bracket is not attached to the tilt mechanism, attach it

using the (4) 1/4-20 x 1/2 Philips Pan Head Screws as shown

below in Illustration 2.

Illustration 2

tep 3

Att

aching the Adapter Bracket to the Flat Panel

Align the tilter and adapter bracket with the hole pattern on the

back of your LCD. Use the (4) four M4-12 Philips Pan Head

Screws to attach the plate to the back of the monitor. See the

lllustration 3 below.

NOTE: If the bracket does not line up with the hole

pattern on the back of your monitor, please

contact our customer service department.

Slide the titler shaft into the hole in the end of the forearm, as

shown in Illustration 4 below.

Illustration 4

Fine Tuning Your Arm

Adapter Bracket

Tilt

Mechanism

Arm

Assembly

Illustration 3

Forearm

1/4-20 x 1/2

Screws

Step 1 Adjusting the Tilt Friction

Tilt the monitor to the preferred angle of viewing and tighten the

Friction Knob.

Friction Knob

Be sure the LCD tilts with resistance.

Not enough friction may cause

the monitor to fall forward

without stopping, possibly

damaging your monitor.

Tilter Shaft

1 2

Summary of Contents

Page 1 - Illustration 3

LCD Monitor ArmModel No. 9103INSTRUCTIONSThe IOP Monitor Arm Model 9103 comes in three parts.Each component is sold separately.1. Mount assembly (ins

Page 2 - Installation Instructions

Illustration 5Step 3 Adjusting Friction JointsEach joint on your new monitor arm has a built in set screwthat allows you to set the degree of friction

Comments to this Manuals

No comments

Innovative Ideas Limited LCD Monitor Arm 9103 User Manual

Browse online or download User Manual for Flat panel accessories Innovative Ideas Limited LCD Monitor Arm 9103. Innovative Ideas Limited LCD Monitor Arm 9103 User's Manual

Summary of Contents

Comments to this Manuals